Freezer Repair Services In Okotoks

Before you call in for help, check to make sure your refrigerator is plugged in and that the circuit breaker hasn’t tripped off. 

If all looks well, we might be facing temperature control malfunctions or a broken compressor overload relay. In which case, you can call your trusted refrigerator repair experts in Calgary.

Before you call in for help, check to make sure your refrigerator is plugged in and that the circuit breaker hasn’t tripped off. 

If all looks well, we might be facing temperature control malfunctions or a broken compressor overload relay. In which case, you can call your trusted refrigerator repair experts in Calgary.

Loud noises are one of the most common problems we’re called in to repair. If your Freezer all of a sudden starts making more noise than usual, it could be because of a broken condenser fan motor or a damaged evaporator fan motor. 

We can check to make sure there isn’t anything caught in the condenser fan and check to make sure the fan motor runs well. A noisy fridge is often caused when the evaporator fan motor in the freezer (behind the rear panel) fails. 

Generally, these noises are much louder when the fridge door is open. If this is the case, we’ll need to replace the evaporator fan motor.

Freezer leaks are a sign of a broken water inlet valve. Condensation could be another reason why you see water around your Freezer . This is a sign that your door isn’t properly sealing shut, either from a broken door latch, bad gasket, or damaged hinges. 

If your door seems fine, you can check for cracks on the water inlet valve. Make sure it’s tightened to the supply water line.

If your ice maker isn’t producing ice or your ice cubes smell off, there’s likely an issue with the temperature control in your freezer. This could also happen from a broken water inlet valve or damaged water fill tube. 

Smelly ice cubes are a sign that your ice maker is working too slow. The freezer temperature must be set between 0 – 5 degrees Fahrenheit (-18 – -15C) for the ice maker to function.

When the Freezer is too warm, it’s a sign there’s a broken inlet damper. If your Freezer is so cold that it’s freezing your food, then there is an issue with the thermistor. 

The thermistor controls the fridge temperature and sends temperature readings to the control board, regulating the power to the compressor and evaporator fan. 

You should call the expert appliance repair service in Calgary to handle such issues for you.

When it comes to the broken water dispenser, the water inlet valve or dispenser actuators are to blame. The water inlet valve supplies water to the dispenser. If the valve is defective or if the water pressure is too low, the valve won’t open. 

The valve requires a minimum of 20 psi to function properly. If the pressure seems right, test for continuity using a multimeter. If there’s no continuity, it’s time to replace the valve.

If the Freezer door isn’t shutting properly, you’ll get a pool of condensation inside the Freezer and possible leakage. Not to mention, your electricity bill will go through the roof as your Freezer works twice as hard to stay cool. 

A faulty door may require new hinges, resealing, latches, and gaskets to close correctly. When it comes to burnt-out light bulbs, we can source the specific bulbs for a wide range of household Freezer models.

Check the defrost heater for any signs of malfunction. A malfunctioning heater can lead to insufficient defrosting and ice accumulation.

If the heater is faulty, replace it with a compatible part.